SecurePoE Multispan PoE injector

DA1100-IN: SecurePoE Multispan 30W PoE injector

The DA1100-IN Multispan PoE injector is ideal for indoor environments where up to four devices require PoE power up to 30W each. With one, two or four through-port models available, you can connect devices to be powered with or without a data connection.

One, two or four output versions are available. Each output has an RJ45 data port,(e.g. from the network switch) and an RJ45 load port for the PoE device, that outputs the data and power.

Outputs have LED indication to show if a compatible device is connected and powered. In addition there are SPCO clean contacts for monitoring the power status of each output. The unit also has power on LED indication and SPCO clean contacts to signal power failure.

Multispan with integrated 5-port network switch

Multispan and MultispanUPS products include a 5-port network switch. Available in an indoor mild steel wall mount enclosure, exterior IP66 weather-resistant enclosure ideal for harsh environments, or simply as a 1U rack-mount product.

These switched Multispan models are ideal for installations where there is limited access to, or availability of, Ethernet ports on the network. Only a single Ethernet data cable is required to send and receive data from up to four devices, whether or not they require Power over Ethernet.

• Network switch pre-installed in Multispan SecurePoE units
• No software to configure
• Network switch and PoE power are both battery-backed in 1.2Ah, 7Ah and 10Ah MultispanUPS models
• Maintain data network during accidental or deliberate power failures or faults
• Gigabit Ethernet delivers high-speed connectivity to enhance network performance
• 200mm Ethernet patch cables to SecurePoE ports included
• Easily keep security infrastructure independent of existing networks
• Only one Ethernet cable is required to bridge to existing network infrastructure
• Ability to extend the range of Power over Ethernet and network, up to 200m between network and PoE devices